Lime kiln Blower
 

Lime kiln Centrifugal Blower
 1.Use

    Lime kiln Centrifugal Blower is designed and produced by our company. It can be mainly used on various Lime kilns. It can be only used for the non-corrosive gas and non-viscosity gas. The temperature should be within 80°C，and the content of grain should be within 150mm/m³.

2.Features

    SHC series Lime kiln Centrifugal Blower is the special used blower for gas-burning kiln. It can replace Blower 9-19 series blower.9-19 series is single-grade impeller type Centrifugal Blower. It has low noise, stability, ling use life and it is convenient to maintain.

3.Model

    Eg:    SH----------------------------“Lime”

C------------------------------Multi-grade low speed Centrifugal Blower , Main shaft speed<3000 r/m

100----------------------------Importing Flow rate is 100m3/min

1.21---------------------------Export Absolute Pressure1.21Kgf/cm²(2100mmH₂0) 

4.Structure and transmission

     The series Centrifugal Blower is made from foundry iron to reduce the noise.
 

5.Rotation direction and position

         Blower should be Counterclockwise rotation, steering wheel turned to see signs, can not reverse the use of air into and out of the machine are straight up.

6.Lime kiln Blower Performance parameter list

3, Lime kiln Centrifugal Blower performance chart

Notes: According to the requirement of the customers, the company can produce the blowers between the flow and pressure in the above picture.

4, Performance Curve
Refer to Picture 3.